In person at the Aurora facility. Technical interview covered Kalman filter estimation and C++ on classes and inheritance. Then behavioral with HR. Offer within 12 days. The campus rep at my school helped set expectations for the technical portion
Questions Asked
1.“Tell me about a time you had to balance technical requirements against budget constraints”
Mechanical Engineer
Aurora, ON
Summer 2026Accepted
University of Waterloo · Mechanical Engineering
3rd year · 3.7+ GPA · 2 past internships
Average Interview
TechnicalResume ReviewMultiple roundsVirtual
They pushed hard on why I chose specific materials in my design project. Technical round was with a couple engineers from product development. GD&T, tolerancing and manufacturing process questions
Questions Asked
1.“What is fatigue failure and what factors contribute to it?”
Electrical Engineer
Aurora, ON
Fall 2025No Offer
McMaster University · Electrical Engineering
2nd year · 2.9-3.2 GPA · 0 past internships
Average Interview
TechnicalVirtual
One interview with a couple engineers, dug into embedded systems and CAN bus protocol. I had light CAN exposure from a project but not deep enough. They were looking for more automotive specific electronics background
Questions Asked
1.“What is a load flow analysis and why do power engineers run them?”
2.“What is a three-phase power system and what are its advantages over single-phase?”
Mechanical Engineer
Aurora, ON
Summer 2026Accepted
University of Waterloo · Mechanical Engineering
3rd year · 3.3-3.6 GPA · 2 past internships
Average Interview
TechnicalIn-PersonMultiple roundsResume Review
They clearly read my resume before the call i could tell. Panel had HR, team lead and two technical people. Asked about PID controllers and design decisions on a specific project. In person at Aurora
Questions Asked
1.“Explain the difference between stress and strain. What's the relationship between them?”